How to pack a solar module?

SOLAR MODULE PACKING AT CITIZEN SOLAR PVT LTD 15.1. GENERAL Every alternate module is protected by corner protectors as shown below, this helps in protecting the module edges from any scratches on the AL frame. Inside the box each module is placed in vertically. Put the module into the carton from one side with protector on four corners.

What if a container is unloaded on the unloading platform?

If the container is unloaded on the unloading platform, it is required to be used with the unloading platform or tooling. The height of the unloading platform and the height of the unloading tooling should be kept at the basic level with the bottom of the container (loading bottom plate), and the height tolerance should be controlled within ±10mm.

How to unpack PV modules?

Unpacking of PV modules should always be done in the vertical manner by two persons as shown in the diagram. Also care should be taken for falling over one module to the other inside the packing box. Modules should be stored in a dry and ventilated environment to avoid direct sunlight and moisture.

What should you not do with a solar module?

Do not drill holes in the frame or glass of the module. Do not treat back sheet and front surface of the module with paint and adhesives. Do not artificially concentrate light on the module.

How are crystalline silicon solar modules packed?

At Citizen Solar the standard packing -1 and standard packing -2 of crystalline silicon solar modules consists of a wooden pallet and a packing box as shown in figures below. 15.3. SPECIAL BOX PACKING

Can solar PV modules be installed in sunlight?

Use of insulated tools and gloves is recommended while working with modules in sunlight. No metallic contacts should be on the human body. The installation of solar PV modules should only be performed by a qualified licensed professional, including, without limitation, licensed contractors and licensed electricians.